March 18, 2022

Baxa Introduces Four New Microfuse Infusion System Administration Sets

Baxa Corporation announces the addition of four specialty administration sets to the MicroFuse® Syringe Infusion System line. These new sets incorporate a T-site for the convenient administration of coronary vasodilators during myocardial perfusion imaging. Their design resulted from customer feedback on safety and ease of administration for this specialty cardiac application.

Englewood, CO (PRWEB) March 18, 2022 -- Baxa Corporation announces the addition of four specialty administration sets to the MicroFuse® Syringe Infusion System line. These new sets incorporate a T-site for the convenient administration of coronary vasodilators during myocardial perfusion imaging. Their design resulted from customer feedback on safety and ease of administration for this specialty cardiac application.

The new MicroFuse Administration Sets feature an integrated, T-site injection port close to the set outlet. This easy-access port facilitates the addition of a secondary medication during cardiac monitoring procedures, minimizing the opportunity for medication error or the introduction of touch contamination. Prior to their release, the available selection of administration sets was limited. The sets offer needleless ports and are available in several convenient lengths to accommodate different clinical practices.

“Baxa has offered a specialty infuser for vasodilation procedures for many years,” explains Mark Thrasher, Market Manager for IV administration products. “The new sets were developed from discussions with cardiac clinics and their technicians. Providers had very specific input on set length, connector types, and specific configurations. They made it easy to respond with products that addressed specific needs.”

The MicroFuse Rapid Rate Infuser is the most popular device for simple, cost-effective administration of adenosine. The new sets complement Baxa Corporation’s existing product line for pharmacologic stress imaging. MicroFuse Administration Sets have a low prime volume to minimize drug waste. Their integrated Y and T connectors make them safer and more efficient than competitive sets used for this application.

Baxa developed the MicroFuse Rapid Rate Infuser specifically for rapid infusion of adenosine during pharmacologic imaging procedures. To accommodate this specialty application, MicroFuse Rapid Rate Infusers deliver a full syringe dose over approximately six or eight minutes, depending on physician requirements.

About Baxa Corporation
Celebrating 30 years of business in 2005, Baxa Corporation is a Denver-based manufacturer of medical devices and systems for preparing, handling, packaging and administering liquid medications. The company manufactures and markets a wide range of healthcare products for use in hospitals, critical care units and alternate-site pharmacies. Privately held, Baxa Corporation has subsidiaries and sales offices in Canada, the United Kingdom; Denmark and Germany; and distribution partners worldwide. Further information is available at http://www.baxa.com

Contacts:
Marian Robinson
Vice President, Marketing
Baxa Corporation:
800.567.2292 ext. 2157
303.617.2157

Maggie Chamberlin Holben
APR
Absolutely Public Relations
303.984.9801
303.669.3558

Posted by Industrial at 03:44 AM | Comments (0)

March 15, 2022

US FDA Approves Marketing of Biomove 3000 for Stroke Rehabilitation. The Highly Affordable Home Therapy System Enters U.S Market

US FDA approves marketing of the highly affordable and easy to use Home Stroke Therapy device Biomove 3000 http://www.biomove.com manufactured by the Israeli company Curatronic Ltd.

(PRWEB) March 15, 2022 -- Hashmonaim, Israel --- Curatronic Ltd. announced today that it has obtained U.S. Food and Drug Administration (FDA) marketing approval for the Biomove 3000 Stroke Rehabilitation system.

The Biomove 3000 system was specifically developed for home therapy following a stroke. The highly affordable battery-powered device detects extremely small electrical EMG signals that persist in paralyzed muscles after a stroke and uses these tiny signals to initiate an electrical stimulation impulse to the muscles, resulting in actual muscle movement by the patient.

FDA 510(k) approval allows Biomove 3000 to be marketed in the United States, where over 700,000 individuals experience a stroke each year. Millions of people suffer from the debilitating effects of stroke. Fifty percent have some one-sided paralysis and seek effective treatment for their severe, long-term disabilities.

Ben Philipson, President of Curatronic Ltd. said, "We are delighted to have received FDA approval for the Biomove 3000 system, which enables us to reach the many stroke victims in the US market with our economical, easy-to-use system.

Further information about the Biomove 3000 system can be found at Curatronic’s Biomove web site: http://www.biomove.com

Curatronic Ltd. was founded in 2000 as a privately held R&D; company dedicated to developing affordable, easy to use state-of-the-art stroke rehabilitation and therapy devices for use by patients at home and by professional therapists.

Curatronic Ltd.
P.O.Box 1532
Hashmonaim
73127 Israel
Tel: 011-972-8976-1441
Fax: 011-972-8976-2020

Posted by Industrial at 11:57 PM | Comments (0)

March 02, 2022

Colours Wheelchairs to Launch New Products at Med Trade

Colours ‘N Motion Wheelchairs (www.ColoursWheelchair.com) and Med Services Europe (www.MedServicesEurope.com) have announced that Colours will be featuring several new products at the Med Trade Show in Las Vegas, April 2005

(PRWEB) March 2, 2022 -- John Box, President of Colours ‘N Motion Wheelchairs (www.ColoursWheelchair.com) and Gene Emmer of Med Services Europe (www.MedServicesEurope.com) have announced that Colours will be exhibiting at the Med Trade Show in Las Vegas, April 2005. (www.medtradespring.com). Colours’ Exhibition booth number is 877. With advance notice, distributors and dealers of wheelchairs can also arrange to visit Colours’ Headquarters in Corona, California, only a 3.5 hour drive from Las Vegas. This can be either before or after Med Trade.

At Med Trade, Colours will be featuring several new products:
- The NEW Spazz-G wheelchair. The Spazz G is a breakthrough wheelchair offering an ultra lightweight, top quality, active wheelchair at one of the lowest prices on the market.
http://www.colourswheelchair.com/products/prod_spazz_g.htm
- Portable Hand Controls for Cars. These hand-controls are simple and easy to use. They allow the driver to use any automatic transmission vehicle, including rental cars. No longer are drivers limited to adapted cars. Click for photos: http://www.colourswheelchair.com/resources/hand_control/idx_az1_01.htm.
- Colours New Cool Billet Wheels (for photos click the link and scroll to bottom) http://www.colourswheelchair.com/resources/chairs_photos/idx_chairs.htm

In addition to our Colours Team, on hand at Med Trade will be Autianya and Briana, famous Hip-Hop dancers and models in our Adult Everyday Catalogue: http://www.colourswheelchair.com/resources/promo/colours_2004cat.pdf
Briana is the model on the Krypto. Autianya is the model for the Boing!. Also, present will be Darwin Holmes the amazing wheelchair acrobat, famous for riding 10 meter skate ramps in a Colours Boing! Wheelchair.

NOTE: Colours is seeking European dealers and distributors interested in exclusivity in their markets. For information contact Gene Emmer at e-mail protected from spam bots or call +31648566707

About Colours:
Colours is a leader in the rehabilitation industry for its design of innovative everyday, sport and pediatric wheelchairs. Colours’ wheelchairs are lightweight, adjustable and customizable. At 14.5 pounds (6.6 kg) the custom-designed Zephyr (http://www.colourswheelchair.com/products/prod_zephyr.htm) is one of the lightest wheelchairs on the market.
The Boing!

(http://www.colourswheelchair.com/products/prod_boing.htm) is the first wheelchair with four-wheel independent suspension. For more information: www.ColoursWheelchair.com. Colours is now expanding in Europe! European distributors interested in distributing Colours Wheelchairs are encouraged to contact Med Services Europe, Colours’ European representative.

About Med Services Europe:
Med Services Europe B.V. is based in Amsterdam, The Netherlands and conducts Sales, Marketing and Business Development services for the Pharmaceutical, Diagnostic and Medical Equipment Industry. Med Services’ specializes in building and managing distribution networks for medical manufacturers in Eastern and Western Europe. We are Colours’ Representative in Europe. European Wheelchair distributors are invited to contact us. www.MedServicesEurope.com Telephone: +31648566707

Posted by Industrial at 01:14 AM | Comments (0)

February 14, 2022

Howard Industries Medical Technology Division Unveils its Integrated Point of Care Cart at HIMSS Conference

Howard Industries® Medical Technology Division unveiled a prototype of its latest product offering — a sleek, ergonomically-designed point of care cart — today at the 2005 annual Healthcare Information and Management Systems Society (HIMSS) conference in Dallas, TX. With an 18” x 19” base, durable work surface, integrated cable management system, and high-performance 35Ah power system, the point of care cart will support a wide range of computing devices including barcode scanners, notebooks, tablets, and small form factor PCs

(PRWEB) February 14, 2022 -- “By scaling down the size of a traditional cart without sacrificing any necessary features, our design team has clearly created a product that is unique to the market,” said Everett E. “Robbie” Robinson, IV, Howard Industries Marketing Communication Manager. “It is quiet, easy to navigate, and can be used while sitting or standing thus making it ideal for any healthcare environment.”

Howard Medical Technology will continue to offer carts from its strategic partners as well as the innovative technology from its sister division, Howard Computers.

About Howard Industries Medical Technologies Division
Howard Medical Technology is a division of Howard Industries, a 500-million dollar, privately-held company headquartered in Laurel, MS. Like its sister divisions, Howard Transformers, Howard Ballast Products, and Howard Computers, Howard Medical Technologies is committed to creating, providing, and supporting superior products and services that meet or exceed the needs of its customers.

About Howard Computers
In addition to over 190,000 different product offerings ranging from laptops, desktops, servers, networks, and networking services that satisfy the demands of every home or business to rugged notebooks and mobile medical carts that enable healthcare personnel focus on patient care with confidence and fewer medical errors – Howard Computers provides tomorrow’s technology today. Visit www.HowardComputers.com/pr to find the solutions you’ve been missing.

Posted by Industrial at 12:48 PM | Comments (0)